Zebex Alpha-70 series Manual do Utilizador descarregar pdf (Página 8)

Start of Configuration

RESET

• The reading of the "RESET” label

turns all the parameters back to

default values.

•

When you intend to turn your

scanner back to default

parameter, please scan the

"Start of configuration" label first,

then scan "RESET" label and

finally scan the "End of

configuration" label.

ABORT

RS-232C

PC/AT

WAND EMULATION

SHOW VERSION

•

The reading of the "ABORT" label

discards all the parameters read

prior to the "End of

configuration".

•

The scanner remains in the last

interface mode when the

scanner is reset. The label

below should be scanned if the

scanner is configured the first

time.

•

The reading of the “ SHOW

VERSION” label will be show

firmware version.

SCANNING MODE SELECTION(for laser scanner)

For series laser scanners, there are 3 scanning modes to

suit your application requirements.

Trigger Mode

Turbo Trigger Mode

The scanner becomes inactive as

soon as the data is transmitted. It

must be triggered to become active

again.

The scanner switch is pressed and

double reading for the same bar

code is permitted. The scanner

will turn off when the trigger switch

is released.

Without any scanning, the unit will

enter a standby mode. To

reactivate the unit, present an

object in front of the IR sensor.

(*Only for Alpha-60 series.)

Object detect Trigger

Note: To avoid hazardous exposure, all laser scanner are

equipped with an internal cut-off security system

which will turn off the laser beam after 5 seconds.

SCANNING MODE SELECTION (For Alpha-70

series)

The scanner becomes inactive as

soon as the data is transmitted. It

must be triggered to become active

again.

In auto scan mode, the scanner is

still active after the data is

transmitted, but the successive

transmission of the same bar code

is not allowed when the trigger

switch is pressed again.

This scanner will light up when

press the scanner trigger switch

once. And, the scanner will turn

off for next pressing.

For testing the response of the

scanner.

For factory testing use only.

Trigger mode

Auto scan mode

Alternate mode

Repeat mode

Testing mode

DATA REDUNDANT CHECK

The option allow you to set decoder

data redundant check.

Enable

Disable

End of Configuration

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 29 30

Comentários a estes Manuais

Sem comentários

Zebex Alpha-70 series Manual do Utilizador Página 8

Comentários a estes Manuais

Manuais e produtos relacionados com Leitores de códigos de barras Zebex Alpha-70 series